DIN41612 connector, also known as European socket connector. It is a type of connector that adopts European standards and is widely used, usually used in chassis. During its installation, positioning accuracy, installation firmness, and replaceability are crucial.The positioning accuracy can ensure that the connector is accurately connected when the circuit board is loaded into the chassis; the installation firmness is used to ensure that the connector does not fall off or shift when the circuit board is pulled out and inserted; the replaceability is used when the same chassis is connected to the upper part. When the device needs to be disassembled or replaced, it can be operated conveniently and quickly.
DIN41612 Connectors mainly have parallel connection and vertical connection. The connection form is: straight hole - curved needle, vertical connection of curved hole - straight needle, parallel connection of curved hole - curved needle. The number of contact points are: 20, 30, 32, 40, 64, 96, 120, 128, 160, etc. The products are used in the connection between the backplane and the daughter board of optoelectronic equipment, the connection between the backplane and the daughter board of industrial control equipment, the industrial control of consumer electronics, the connection between the backplane and the daughter board of industrial control security control, etc. Its application industry: used in consumer electronics, monitors, computers, PCB boards, instrumentation, intelligent robots, electrical appliances, new energy vehicles, color TVs, air conditioners, photovoltaics, security, mobile phone industry, CNC and other industries!
DIN 41612 was a DIN standard for electrical connectors that are widely used in rack based electrical systems. Standardisation of the connectors is a pre-requisite for open systems, where users expect components from different suppliers to operate together. The most widely known use of DIN 41612 connectors is in the VMEbus and NuBus systems. The standard has withdrawn in favor of international standards IEC 60603-2 and EN 60603-2.
DIN 41612 connectors are used in Pancon STEbus, Futurebus, VMEbus, Multibus II, NuBus, VXI Bus,eurocard TRAM motherboards,and Europe Card Bus, all of which typically use male DIN 41612 connectors on Eurocards plugged into female DIN 41612 on the backplane in a 19-inch rack chassis.
